We ONLY carry the Poly shroud as of 2-18-20.
The receiver mounted 8 round stainless tube for the Stoeger M3000 series of shotguns.
The stainless steel one piece tube eliminates the need for a clamp and removes the intermediate threads and nut to improve feeding reliability and slug accuracy. In addition, it greatly eases disassembly and improves function with lower powered shotshells. The poly shroud protects the mag tube as well as provides a solid assembly. No other tube on the market except the stock FNH SLP™ tube, properly eliminates the stress riser due to the midtube nut and completely shields the tube installed into the receiver. These are two features we would not do without on a hard use autoloading shotgun, and now you don't have to do without either.
The 8+ versions utilize the Nordic MXT extension components and are fully interchangeable.
Gunsmith installation suggested. Remove the stock magazine tube from the receiver and clean the threads with a solvent. In some cases, a heat gun may be helpful. Install the stainless tube until bottomed out. We have not used any threadlocker on some tubes and they work fine. If you use the included thread locker, remove the receiver strike plate, ensure the threads are clean and degreased first. If the loading port is opened, you will see the edge of the stainless tube protrude into the loading port. Mark with a sharpie, remove tube and remove the marked portion. Reinstall tube, install spring after clipping to desired length, install nut (without extension) until shroud is compressed. Thread extension into nut. Hand tight snugged up is plenty...don't crank down on the extension! The extension can be thread locked into the nut if you prefer.
